Configuring Adaptive Agent Settings After Deployment; Configuring Agent Settings On The Management Zone Level - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SYSTEM ADMINISTRATION REFERENCE 10.3 16-04-2010 System Administration Manual

Configuring Adaptive Agent
1 4
Settings after Deployment
By default, the ZENworks Adaptive Agent is deployed with the features selected at the Management
Zone level in the Agent Features panel of ZENworks Control Center. For more information on how
to customize the agent features during deployment, see
After the deployment, you can choose to uninstall, enable or disable the Adaptive Agent features,
configure the agent's cache, set retry settings, and select whether to let users uninstall the agent.
You can configure settings at three levels:
Management Zone: The setting applies to all devices in the Management Zone.
Device Folder: The setting applies to all devices contained within the folder or its subfolders.
It overrides the Management Zone setting.
Device: The setting applies only to the device for which it is configured. It overrides the
settings established at the Management Zone and folder levels.
The following sections contain more information:
Section 14.1, "Configuring Agent Settings on the Management Zone Level," on page 145
Section 14.2, "Configuring Agent Settings on the Device Folder Level," on page 147
Section 14.3, "Configuring Agent Settings on the Device Level," on page 147
Section 14.4, "ZENworks Agent Settings," on page 148
14.1 Configuring Agent Settings on the
Management Zone Level
1 In ZENworks Control Center, click the Configuration tab.
2 In the Management Zone Settings panel, click Device Management.
"Customizing Features before

Configuring Adaptive Agent Settings after Deployment

14
Deployment".
145