Step 2. Set Up The Directory For Pin-Based Enrollment; Step A. Check The Directory For User Entries - Netscape MANAGEMENT SYSTEM 6.0 Installation And Setup Manual

If you decided to use the portal authentication module, note the LDAP
directory-specific information.
• Determine the enrollment form you want your users to use. Decide whether
you want to customize it.
The next step depends on the authentication module you chose:
• If you decided to use the directory- and PIN-based authentication module, go
to the next step, "Step 2. Set Up the Directory for PIN-Based Enrollment" on
page 503.
• For all other modules, skip to "Step 4: Add an Authentication Instance" on
page 509.
Step 2. Set Up the Directory for PIN-Based
Enrollment
Complete this step only if you want to configure the server to use the directory-
and PIN-based authentication method (with or without PIN removal). Otherwise,
skip to the next step.
To set up a directory for PIN-based authentication method:
•

Step A. Check the Directory for User Entries

• Step B. Update the Directory
• Step C. Prepare the Input File
• Step D. Run the Command Without the Write Option
• Step E. Check the Output File
• Step F. Run the Command Again with the Write Option
Step A. Check the Directory for User Entries
Before you run the PIN Generator tool, make sure that the directory you intend to
use for generating PINs has been populated with end-user entries that require
PINs. It is also a good idea to confirm with that directory's administrator that all
pending directory requests have been processed before the PIN Generator starts its
operation.
Configuring Authentication for End-User Enrollment
Chapter 15 Setting Up End-User Authentication 503