Netscape MANAGEMENT SYSTEM 6.0 Installation And Setup Manual page 411

Step 5. Configure Certificate Manager's Connector Settings
In this step you configure the connector settings of the Certificate Manager. This
enables the Certificate Manager to utilize the proprietary HTTPS connectors to
communicate with the Data Recovery Manager (following successful SSL client
authentication).
Note that during the installation of a Data Recovery Manager, you were prompted
to specify the host name and port number of the Certificate Manager to which the
Data Recovery Manager will be connected. If you specified this information, you
are not required to go through this step. However, it is recommended that you
verify the connector setting and make sure that the information you entered during
installation is correct.
Log in to the CMS window for the Certificate Manager (see "Logging In to the
1.
CMS Window" on page 333).
In the navigation tree, select Certificate Manager.
2.
The General Settings tab appears in the right pane.
Select the Connectors tab.
3.
Chapter 13 Managing Privileged Users and Groups
Setting Up Privileged Users
411