Removing Sfp Modules - Cisco 2010 Hardware Installation Manual

Installing SFP Modules
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
Figure 5-5
Do not remove the optical port plugs from the SFP until you are ready to connect cabling.
Caution
Connect the network cable to the SFP module.
Step 2

Removing SFP Modules

Follow these steps to remove an SFP from a Cisco 2010 CGR router:
Disconnect all cables from the SFP.
Step 1
Caution The latching mechanism used on many SFPs locks the SFP into place when cables are connected. Do not
pull on the cabling in an attempt to remove the SFP.
Disconnect the SFP latch (see
Step 2
Note SFP modules use various latch designs to secure the module in the SFP port. Latch designs are not linked
to SFP model or technology type. For information on the SFP technology type and model, see the label
on the side of the SFP.
Cisco Connected Grid Routers 2010 Hardware Installation Guide
5-8
Installing an SFP Module
E N
C F
P S U
A C T
1
2
E N
S F P 0 /0
S P D
S F P 0 /1
S Y S 0
1
Figure 5-6).
Chapter 5 Installing and Upgrading Internal Modules
G E 0 /1
G E 0 /0
C
OL-21559-01