Table of Contents
Advertisement
Installing the Cisco ASR 907 Router
Connecting a Management Ethernet Cable
When using the Ethernet Management port in the default mode (speed-auto and duplex-auto) the port operates
in auto-MDI/MDI-X mode. The port automatically provides the correct signal connectivity through the
Auto-MDI/MDI-X feature. The port automatically senses a crossover or straight-through cable and adapts to
it.
However, when the Ethernet Management port is configured to a fixed speed (10 or 100 Mbps) through
command-line interface (CLI) commands, the port is forced to MDI mode.
When in a fixed-speed configuration and MDI mode:
• Use a crossover cable to connect to an MDI port
• Use a straight-through cable to connect to an MDI-X port
Warning
To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, connect
the Management Ethernet ports only to intra-building or unexposed wiring or cable. The intrabuilding cable
must be shielded and the shield must be grounded at both ends. The intra-building port(s) of the equipment
or subassembly must not be metallically connected to interfaces that connect to the OSP or its wiring. These
interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE) and require isolation from the exposed OSP cabling. The addition of Primary Protectors is
not sufficient protection in order to connect these interfaces metallically to OSP wiring.
Installing and Removing SFP and XFP Modules
The Cisco ASR 907 Router supports a variety of SFP and XFP modules, including optical and Ethernet
modules. For information on how to install and remove SFP and XFP modules, see the documentation for the
SFP or XFP module at
http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html
For information about inspecting and cleaning fiber-optic connections, see
http://www.cisco.com/en/US/partner/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtml
Caution
We recommend that you wait 30 seconds between removal and insertion of an SFP on an interface module.
This time is recommended to allow the transceiver software to initialize and synchronize with the standby
RSP. Changing an SFP more quickly could result in transceiver initialization issues that disable the SFP.
Connecting a USB Flash Device
To connect a USB flash device to the Cisco ASR 907 Router, insert the memory stick in the USB port labeled
MEM. The Flash memory module can be inserted in only one way, and can be inserted or removed regardless
of whether the router is powered up or not.
The figure below shows the USB port connector on the Cisco ASR 907 Router.
Connecting a Management Ethernet Cable
Cisco ASR 907 Router Hardware Installation Guide
101
Advertisement
Table of Contents
