Disabling Partner Firmware Upgrade
If a service technician tells you to disable partner firmware upgrade:
1. Select Manage > General Config > System Configuration.
2. Set Partner Firmware Upgrade to Disabled.
Changing Utility Priority
You can change the priority at which the Verify, Reconstruct, Expand, and Initialize
utilities run when there are active I/O operations competing for the system's
controllers.
Priority Value
High
Medium
Low
To change utility priority:
1. Select Manage > General Config > System Configuration.
2. For Utility Priority, select a priority.
3. Click Change System Configuration.
Description
Use when your highest priority is to get the system back to a fully
fault-tolerant state. This causes heavy I/O with the host to be slower
than normal. This value is the default.
Use when you want to balance data streaming with data redundancy.
Use when streaming data without interruption, such as for a web
server, is more important than data redundancy. This enables the
Reconstruct or other utility to run at a slower rate with minimal
effect on host I/O.
Chapter 6 Additional Configuration Functions and Utilities
183