Updating Drive Enclosure Firmware - HP 2000fc Reference Manual

Total Number of this Type – The number of expansion modules that have the
■
same vendor, model, and firmware revision. For example, two identical
expansion modules with different firmware revisions are considered to be
different types. If firmware update is not supported for an expansion module
type, the Select column shows "Not Supported" for that type and you cannot
continue the firmware update process.

Updating Drive Enclosure Firmware

You can update drive enclosure firmware by loading a firmware update file obtained
from the enclosure vendor.
Caution –
inaccessible. Stop all I/O to virtual disks before performing this operation.
To update drive enclosure firmware:
1. Obtain the firmware update file and store it in a network location that SMU can
access.
2. Select Manage > Update Software > Enclosure Firmware > Update Firmware.
3. Select the type of expansion modules to update.
Expansion modules that have the same manufacturer, model, and firmware revision
are considered the same type. For example, two identical expansion modules with
different firmware revisions are considered to be different types.
4. Click Select Type And Continue.
Enclosure processors of the type you selected are listed and the following
information is displayed for each enclosure:
Device WWN – The drive enclosure's node World Wide Name.
■
Address – The channel and loop ID of the expansion module.
■
Manufacturer – The expansion module manufacturer.
■
Model – The expansion module model number.
■
Rev – The revision code for the firmware currently in the expansion module.
■
If more than two enclosure modules are listed, a Select All check box is displayed.
5. Select the enclosure modules to update.
6. Click Continue.
7. Click Browse to select the firmware update file.
146 HP StorageWorks 2000 Family Modular Smart Array reference guide • August 2008
Updating enclosure firmware causes all disk drives to be temporarily