HP 2000fc Reference Manual page 119

3. Select a volume.
The Volume Information panel shows the following information, depending on the
type of volume selected.
Volume Type Field
(All) Volume Type
(not shown for standard
volumes)
Volume Name
Belongs to Virtual Disk
Volume is presented to all
hosts not explicitly mapped
Standard Volume Size
Percent of Total Virtual
Disk
Snap Pool Free Space
Master Volumes
Snapshots
Thresholds
Master Volumes on this
Snap Pool
Description
One of the following volume types:
Master – A standard volume that is enabled for
snapshots and is associated with a snap pool.
Snap Pool – A virtual volume in which snapshots of
the associated master volume are stored.
Snapshot – A volume that preserves the data state of a
master volume at the point in time when the snapshot
was created.
Name assigned to the volume.
Name of the virtual disk the volume is part of.
Specifies whether the volume is visible to all
connected hosts. If the value is Yes, the LUN is also
shown.
Volume size in Mbyte. To change the volume size, go
to Volume Menu > Expand Volume.
The percentage of the total virtual disk that this
volume occupies.
The amount of free space in the snap pool.
The number of master volumes using the snap pool.
The number of snapshots in the snap pool.
For each threshold level, the action configured to occur
when snap-pool usage reaches the specified
percentage. For information about thresholds, see
"Setting Snap Pool Policies and Thresholds" on
page 110.
If the snap pool contains snapshots, the name of each
associated master volume, the number of snapshots
taken, and their total size.
Chapter 3 Managing Storage 119