HP 2000fc Reference Manual page 293

TABLE E-1 Event Descriptions and Recommended Actions (Continued)
Event
Code Event Type
225 Critical
226 Critical
227 Critical
228 Critical
229 Warning
230 Warning
231 Critical
232 Warning
Description
Background master write copy-on-
write operation has failed.
There was an internal I/O error.
Could not complete the write
operation to the disk.
A background master volume
rollback failed to start due to inability
to initialize the snap pool. All
rollback is in a suspended state.
Failure to execute rollback for a
particular portion of the master
volume.
Background rollback for a master
volume failed to end due to inability
to initialize the snap pool. All
rollback is in a suspended state.
The snap pool has reached the snap
pool warning threshold.
The snap pool has reached the snap
pool error threshold.
The system will take the action set up
in the policy. Default is to delete the
oldest snapshot.
The snap pool has reached the snap
pool critical threshold.
The system will take the action set up
in the policy. Default is to delete all
snapshots on the snap pool.
The maximum number of enclosures
allowed for the current configuration
has been exceeded.
Recommended Action
A probable hardware failure has
prevented the software from
operating successfully. Isolate and
replace and failed hardware
components. Once the hardware
issues have been corrected, it might
be necessary to delete all snapshots
and restart the controller.
Make sure the snap pool and the
vdisk on which this volume exists
are online. Restart the rollback
operation.
Restart the rollback operation.
Make sure the snap pool and the
vdisk on which this volume exists
are online. Restart the rollback
operation.
The user can set up the policy for
the snap pool.
You can expand the snap pool or
delete snapshots.
If the policy is to halt writes, then
you must free up space on the snap
pool master, or convert the master
volume to a standard volume in
order to resume operations.
The platform does not support the
number of enclosures that are
configured. The firmware has
removed the enclosure indicated by
this event from its configuration.
Appendix E Event Codes 293