Configuring A Syslog Ip Address; Removing A Syslog Ip Address - Brocade Communications Systems 8 Administrator's Manual

3. Click Netstat Performance.
4. Select the Auto Refresh check box to automatically refresh the statistics details.
5. When enabled, enter the interval time in seconds in the Auto-Refresh Interval field.

Configuring a syslog IP address

The syslog IP represents the IP address of the server that is running the syslog process. The syslog
daemon reads and forwards system messages to the appropriate log files or users, depending on
the system configuration. When one or more IP addresses are configured, the switch forwards all
error log entries to the syslog on the specified servers. Up to six servers are supported. Refer to
Fabric OS Administrator's Guide for more information on configuring the syslog daemon.
Use the following procedure to configure a syslog IP address.
1. Open the Switch Administration window as described in
2. Select the Network tab.
3. In the Syslog IP's Configuration section, in the New IP field, enter an IP address in either IPv4
4. Click Add.
5. Click Apply.

Removing a syslog IP address

Use the following procedure to remove a syslog IP address.
1. Open the Switch Administration window as described in
2. Select the Network tab.
3. Select a syslog IP in the table and click Remove.
4. Click Apply.
Web Tools Administrator's Guide
53-1001772-01
DRAFT: BROCADE CONFIDENTIAL
Clear the check box to disable auto refresh.
The statistics details are automatically refreshed, based on the configured time interval.
window" on page 35.
or IPv6 format.
The new IP address displays in the Syslog IP area.
window" on page 35.
You can click Clear All to remove all of the syslog IP addresses from the table.

Configuring a syslog IP address

"Opening the Switch Administration
"Opening the Switch Administration
3
37