Displaying Fcoe Port Information; Figure 67 Fcoe Ports Tab, Port Administration Panel - Brocade Communications Systems 8 Administrator's Manual

6. Under Login Member Configuration, select either Allow All Members or Allow Specific Member.
7.

Displaying FCoE port information

There are 24 internal FCoE Ports that bridge FC and Ethernet traffic. You can view FCoE port
information from the Port Administration panel.
Use the following procedure to display FCoE port information.
1. Select the FCoE Ports tab on the Port Administration panel.
2. To view information for a specific port, select the trunk in the FC
Web Tools Administrator's Guide
53-1001772-01
DRAFT: BROCADE CONFIDENTIAL
•
Self — WWN of your current switch
•
Other Switch WWN
If you choose Other Switch WWN, you must enter the WWN of that switch in the provided field.
•
If you select Allow All Members, all devices attached to FCoE ports are allowed to log in to
the switch.
•
If you select Allow Specific Member, you can control which devices can log in, using
Member Type, Member PWWN/MAC, and the Add and Remove buttons, as described
below.
a. Select Model2 as Member Type.
a. Enter the port WWN in hexadecimal format in the Member PWWN/MAC field, and click
Add.
The WWN displays under Allowed Login Members. If you decide a member should not be
on the list, highlight the entry and click Remove.
Click OK.
The initial view displays a summary of all FCoE ports on the switch
FIGURE 67
FCoE Ports tab, Port Administration panel
port in the FCoE Port Configuration and Management table and click View Details.
Port information displays in three tabs. The General tab is pre-selected.
The Connected Devices tab displays information about devices connected to the switch
(Figure 67). Six columns of information are displayed:
•
Device WWN displays the WWN of the connected device.
•
Device MAC displays the MAC address of the connected device.
Displaying FCoE port information
(Figure 67).
E Ports Explorer or select the
0
19
265