Configuring Fms Mode Parameters; Displaying Code - Brocade Communications Systems 8 Administrator's Manual

18
Displaying code page information
TABLE 22
Parameter
Director Clock
Alert Mode
Host Control
Prohibited

Configuring FMS mode parameters

Use the following procedure to configure FMS mode parameters.
1. Select a FICON-enabled switch from the Fabric Tree.
2. Open the Switch Administration window as described in
3. Select the FICON CUP tab.
4. To enable or disable an FMS mode parameter, click the check box next to the parameter.
Displaying code page information
The Code Page section identifies the language used to exchange information between the FICON
director and Host Programming. It is a read-only field in Web Tools, as it is set by Host Programming
only. When FMS mode is disabled, the code page is displayed as unavailable.
Use the following procedure to display code page information.
1. Select a FICON-enabled switch from the Fabric Tree.
2. Open the Switch Administration window as described in
3. Select the FICON CUP tab.
246
DRAFT: BROCADE CONFIDENTIAL
FMS mode parameter descriptions (Continued)
Description
Controls behavior for attempts to set the switch timestamp clock through the director console.
When it is enabled, the director console (Web Tools, in this case) displays warning indications
when the switch timestamp is changed by a user application. When it is disabled, you can
activate a function to automatically set the timestamp clock. There is no indication for
timestamp clock setting.
This parameter is set as disabled by the hardware after system installation, and can be reset
by Web Tools.
Determines whether host programming allows modifying port connectivity.
Enabling this mode prohibits host programming control of port connectivity; otherwise, host
programming can manage port connectivity.
This parameter is set as disabled by the hardware after system installation. and can be reset
by Web Tools.
window" on page 35.
The FICON CUP page displays the FICON Management Server page. All attributes on this page
are read-only until FMS mode is enabled.
A checked check box indicates that the parameter is enabled. You cannot configure the User
Alert Mode parameter in Web Tools, as it is read-only.
window" on page 35.
The FICON CUP page displays the FICON Management Server page in front. All attributes on
this tab are read-only until FMS mode is enabled.
The code page format is displayed in the Code Page section as shown in the following example:
Language used to exchange information with Host Programming: (EBCDIC)
USA/Canada -- 00037
"Opening the Switch Administration
"Opening the Switch Administration
Web Tools Administrator's Guide
53-1001772-01