Displaying Version Information - Brocade Communications Systems PowerConnect B-RX Release Note

4. In most cases, this is all that will be required. If you are directed by the release notes to upgrade the
boot image, use the upgrade procedure for upgrading the BigIron RX Series switches boot image,
presented later in this document.
5. Reboot the BigIron RX Series switch.

Displaying version information

Prior to upgrading the images on a BigIron RX Series switch, it is advisable to check the versions already
installed. It is also useful to check the versions installed immediately after an upgrade has been done to
make sure that you have installed the versions required in your installation. The following sections
describe how to use the show version commands to display this information.
You can display version information for a BigIron RX using the show version command as shown in the
following:
BigIron RX# show version
==========================================================================
HW: BigIron RX Router
BigIron RX-8 CHASSIS (Serial #: SA35065043, Part #: 31549-000B)
RX-BI-SFM3 Switch Fabric Module 1 (Serial #: SA43080812, Part #: 35523-201B)
FE 1: Type fe200, Version 2
FE 2: Type fe200, Version 2
FE 3: Type fe200, Version 2
RX-BI-SFM3 Switch Fabric Module 2 (Serial #: SA42081175, Part #: 35523-201B)
FE 1: Type fe200, Version 2
FE 2: Type fe200, Version 2
FE 3: Type fe200, Version 2
RX-BI-SFM3 Switch Fabric Module 3 (Serial #: SA42081159, Part #: 35523-201B)
FE 1: Type fe200, Version 2
FE 2: Type fe200, Version 2
FE 3: Type fe200, Version 2
==========================================================================
SL M2: RX-BI-MR Management Module Active (Serial #: SA11080037, Part #: 35524-
102A):
Boot : Version 2.8.0T145 Copyright (c) 1996-2010 Brocade Communications
Systems, Inc.
Compiled on Apr 20 2011 at 01:07:14 labeled as rmb02800
(439602 bytes) from boot flash
Monitor: Version 2.8.0T145 Copyright (c) 1996-2010 Brocade Communications Systems,
Inc.
Compiled on Apr 20 2011 at 01:07:14 labeled as rmb02800
(439633 bytes) from code flash
IronWare: Version 2.8.0T143 Copyright (c) 1996-2010 Brocade Communications Systems,
Inc.
Compiled on Apr 20 2011 at 01:12:50 labeled as rmpr02800
(4550480 bytes) from Primary
Board ID: 00 MBRIDGE Revisions: 21
916 MHz Power PC processor (version 8003/0101) 166 MHz bus
512 KB Boot Flash (AM29LV040B), 32 MB Code Flash (MT28F128J3)
1024 MB DRAM
IronWare Software Release 02.8.00a for Brocade BigIron RX Series Swtches
Release Notes v 1.0 Page 14 of 40