Access Gateway And Brocade Mibs; Firmware Upgrades And Enabled Traps - Brocade Communications Systems 8 Reference Manual

1

Access Gateway and Brocade MIBs

4. In the Manager (SNMP Browser), create a user snmpadmin1 with Authentication protocol as

Access Gateway and Brocade MIBs

Brocade Access Gateway supports the following MIBs
TABLE 3
.
MIB name
MIB-2
Entity-MIB
HA-MIB
SW-MIB
FA-MIB
FE-MIB
CPQ-Rack MIB
FCIP MIB
iSCSI MIB
IF-MIB
BD-MIB

Firmware upgrades and enabled traps

The pre- Fabric OS v4.4 firmware had trap group level settings i.e, traps were turned on and off as a
group. In Fabric OS v4.4 or later, you can turn on and off traps individually within a trap group.
When you upgrade to the Fabric OS v4.4 firmware or later, by default the individual traps are turned
off even if the corresponding trap group was enabled before upgrading. So you must use the
snmpconfig command to turn on explicitly the individual traps within each trap group.
16
SNMP GET Security Level: Authentication and Privacy
SNMP SET Security Level: Authentication and Privacy
noAuth, Privacy protocol as noPriv, set the password and set the trap port as 162. (Same
values are set as in the switch SNMPv3 configuration.)
Access Gateway MIB support
Supported
Yes
Yes
Yes
No
Yes
No
Limited
Limited
Limited
Yes
Yes
(Table 3)
Description
Updated to support Access Gateway in v5.2.1.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
The connUnitSnsTable is not supported because a switch in Access
Gateway does support name server services.
Disabled in Access Gateway because the conventions are specific to
fabric switches.
Supported on embedded switches only.
Implemented to support WAN interfaces in Fabric OS v5.3.0.
Supports displaying information about virtual targets (VTs), iSCSI
sessions, and TCP connection tables, as derived from specific MIB
tables.
Supported for F-ports.
Fabric OS MIB Reference
53-1001768-01