Brocade Communications Systems 8 Reference Manual page 269

•
•
•
•
For an external FC port, this value should be 9 (shortwaveNoOFC), 8 (longwaveNoOFC), or 6
(copper).
connUnitPortModuleType 1.3.6.1.3.94.1.10.1.9
The module type of the port connector.
Values Possible values are:
•
•
•
•
•
•
•
•
•
For an external FC port with GBIC, this value is set to 6 (gbicSerialId) or 7 (gbicNoSerialId). For an
external FC port without GBIC, this value is set to 8 (gbicNotInstalled).
connUnitPortWwn 1.3.6.1.3.94.1.10.1.10
The World Wide Name of the port, if applicable; otherwise, an empty string.
This is in IEEE Extended format, and the extension contains the internal port number of each port.
NOTE
The internal port number is 1 less than the port index. For example, if the switch has WWN
10:00:00:60:69:10:02:18, then port numbers 0 and 6 have WWN 20:00:00:60:69:10:02:18 and
20:06:00:60:69:10:02:18, respectively. However, the embedded port has WWN
10:00:00:60:69:10:02:18, the same as the switch.
connUnitPortFCId 1.3.6.1.3.94.1.10.1.11
This is the assigned Fibre Channel ID of this port. This value is expected to be a Big Endian value of
24 bits. If this is a loop, then it is the AL_PA that is connected. If this is an E_Port, then it contains
the domain ID and area, left justified, 0 filled. If this port does not have a Fibre Channel address,
return all bits set to 1.
For an F_Port, this is the Fibre Channel ID to which the connected N_Port is assigned. For an
FL_Port, this is the Fibre Channel ID of the FL_Port. For a U or E_Port, this is similar to F_Port.
Fabric OS MIB Reference
53-1001768-01
longwaveNoOFC (8)
shortwaveNoOFC (9)
longwaveLED (10)
ssa (11) (Not supported in Fabric OS v2.6.1.)
unknown (1)
other (2)
gbic (3)
embedded (4) Fixed (oneXnine)
glm (5)
gbicSerialId (6)
gbicNoSerialId (7)
gbicNotInstalled (8)
smallFormFactor (9)
connUnitPortModuleType 1.3.6.1.3.94.1.10.1.9
8
251