Ricoh Aficio SP W2470 Software Manual page 286

Monitoring and Configuring the Printer
SMTPC: username or password wasn't cor-
rect. [response code] (information)
Snmp over IPv4 is ready
Snmp over IPv6 is ready.
Snmp over IPX is ready.
snmpd start.
started.
Started.
Terminated.
The print server received error <error num-
ber> during attempt to log in to the network.
Access to the network was denied. Verify that
the print server name and password are cor-
6
rect.
trap account is unavailable.
usbd is disable.
WINS name registration: No response to serv-
er <WINS server address>
WINS wrong scopeID= <Scope ID>
wpa authentication Failed
wpa authentication started
wpa IEEE802.1X started
wpa connecting to authenticator
wpa link up
wpa probe response doesn't have IE.
wpa success authenticated
wpa success key received
272
Message Problem and solutions
Connection to the SMTP server failed, because
the specified SMTP user name is incorrect, or
the specified SMTP password is incorrect.
Check the SMTP user name and password.
Communication over IPv4 with snmp is
available.
Communication over IPv6 with snmp is
available.
Communication over IPX with snmp is
available.
The snmpd service has started.
The direct print service has started.
The bonjour function is enabled.
The bonjour function is disabled.
Login to the file server failed. The print server
is not registered or a password is specified.
Register the print server without specifying a
password.
v3Trap cannot be sent. This could be because
the Trap destination account is different from
the account specified by the printer.
Plug and Play function and printing is dis-
abled because usbd is disabled in the security
mode.
Enable usbd in the security mode.
There was no response from the WINS server.
Check the correct WINS server address is en-
tered. Alternatively, check the WINS server is
functioning properly.
An invalid scope ID was used. Use a valid
scope ID.
WPA authentication failed. Check the WPA
configuration.
WPA authentication has started.
WPA authentication has started.
WPA is connecting to authenticator.
WPA key exchange has finished, and commu-
nication has been terminated.
WPA probe response does not have IE.
WPA authentication was successful.
WPA key reception was successful.