When Using The Postscript 3 Printer Driver; Form Feed; Banner Page - Ricoh Aficio SP W2470 Software Manual

Preparing for Printing

When using the PostScript 3 Printer Driver

Follow the procedure below to set up the PostScript 3 printer driver.
1
Important
❒ In an IPv6 environment, NetWare servers cannot be used.
A
In the [Printers] or [Printers and Faxes] window, open the printer properties.
B
Click the [PostScript] tab.
If you are using Windows 2000/XP or Windows NT4.0, click the [Device Set-
tings] tab, and then clear the check boxes.
C
Click [Advanced].
D
Clear the [Send CTRL+D before job] and [Send CTRL+D after job] check boxes, and
then click [OK].
E
Click [OK] to close the printer properties dialog box.

Form Feed

Do not use NetWare to configure form feed. Form feed is controlled by the print-
er driver on Windows. If NetWare form feed is configured, the printer may not
print properly.
Follow the procedure below to disable form feed according to the operating sys-
tem used:
• Under Windows 95/98/Me, clear the [Form feed] check box on the [Printer Set-
tings] tab in the printer properties dialog box.
• Under Windows 2000/XP, Windows Server 2003/2003 R2, or Windows NT
4.0, clear the [Form feed] check box on the [NetWare Settings] tab in the printer
properties dialog box.

Banner Page

Do not use NetWare to configure a banner page.
Follow the procedure below to disable banner pages according to the operating
system used:
• Under Windows 95/98/Me, clear the [Enable banner] check box on the [Printer
Settings] tab in the printer properties dialog box.
• Under Windows 2000/XP, Windows Server 2003/2003 R2, or Windows NT
4.0, clear the [Enable banner] check box on the [NetWare Settings] tab in the print-
er properties dialog box.
44