Gl/2 Print Settings - Ricoh Aficio SP W2470 Software Manual

GL/2 Print Settings

Specify print settings of HP-GL and HP-GL/2 data.
❖ Hard Clip
Enables and disables output hard clip limits given by PS commands. If "Off"
is selected, the actual drawing area will be the printed area.
❖ Centring
Print images at the centre of the hard clip area.
❖ SP Command
Specify whether to eject paper at receipt of "SP;" and "SP0;" command.
❖ Transparency Mode
Specify the transparent processing mode by MC command and TR command.
• Always Active
Always activates MC/TR commands in HP-GL2 data come into effect.
• Use File Defaults
Follows MC/TR commands in HP-GL2 data.
• Always Inactive
Ignores MC/TR commands in HP-GL2 data forcibly.
❖ Source Transparency Mode
Specify the transparent processing method by "Source Transparency Mode
(ESC*v#N)".
• Always Active
Always activates ESC*v#N commands in RTL data come into effect.
• Use File Defaults
Follows ESC*v#N commands in RTL data.
• Always Inactive
Ignores ESC*v#N commands in RTL data forcibly.
❖ Adjust X Offset
Specify X-axis offset for origin of the drawing area in 1 mm increments within
the range between -199 and 199 mm.
❖ Adjust Y Offset
Specify Y-axis offset for origin of the drawing area in 1 mm increments within
the range between -199 and 199 mm.
❖ Brightness
Adjust brightness for RGB-color and grayscale image data. Higher brightness
value lightens the entire image while lower brightness value darkens the im-
age.
Print Settings for GL/2 & TIFF
5
163