Ricoh Aficio SP W2470 Software Manual page 189

Parameters that can be used with SD and AD commands
The standard and substitute character sets (SD and AD commands respectively)
define each character set's attributes, such as font, font spacing, pitch height, and
character width. The table below shows which of the attributes shown in the HP-
GL/2 manual can be used with HP-GL/2.
Types and attributes
1
2
3
4
5
6
7
❖ Character Set
Character set attributes define the character sets used as the standard and
substitute character set. The table below shows the character sets that the HP-
GL/2 filter can use. If an unusable character set is specified, the default set is
applied.
Character set
0 and 277
11
22
43
101
278
300
332
364
396
428
531
numbers higher than 1000
Character set
Font spacing
Pitch
Height
Character tilt
Line width
Font
Description
Roman8
JIS ASCII
Arabic
Katakana
Shift JIS
Arabic-8
Ventura ITC Zapf Dingbats
PS ITC Zapf Dingbats
ITC Zapf Dingbats 100
ITC Zapf Dingbats 200
ITC Zapf Dingbats 300
HP-GL Download
Kanji code
Default value
277
0
Depends on paper size Characters per inch
Depends on paper size Font point
0
0
3
If you select this font, the dis-
play might not be as intend-
ed, depending on the area
you want to use.
If you select this font, the dis-
play might not be as intend-
ed, depending on the area
you want to use.
Printable GL/2 Files
Description
Roman8
Fixed spacing
Upright
Normal
Courier
Note
5
175