Hole Punching - Muratec MFX-2350 User Manual

COPY
Chapter2

Hole punching

The optional punch kit is required to use this function.
2-90
●
COPY Chapter2
1
Load the document.
2 Press the <COPY> key.
3 Press [Finishing].
4
(1) Press [Punch].
(2) Select the desired punch
position.
(3) Press [Enter].
(4) If you want to staple the
document as well, press
[Staple] and follow the
directions on page 2-87.
5 Press [Enter].
6 Adjust any additional copy
settings.
7 Press the <Start> key.
Advanced Copy Features
Copy Ready Copy Ready
Memory Memory
Doc.Type Doc.Type
Auto Auto
Contrast Contrast
Auto Auto
DuplexCopy DuplexCopy
OFF OFF
LTR LTR
Zoom Zoom
100% 100%
LTR LTR
Finishing Finishing
LGL LGL
OFF OFF
11x17 11x17
Others Others
Copy Ready Copy Ready
Select the desired sorting method Select the desired sorting method
and select [Enter]. and select [Enter].
Cancel Cancel
Finishing Finishing
No Sort No Sort Sort Sort Shift Shift
Shift Sort Shift Sort
Staple Staple Punch Punch
OFF OFF OFF OFF
Copy Ready Copy Ready
Select the punch position and select [Enter]. Select the punch position and select [Enter].
Punch Punch Cancel Cancel
OFF OFF 2 holes 2 holes 3 holes 3 holes
When setting the document, When setting the document,
the leading edge will be the leading edge will be
hole-punched. hole-punched.
Set Set 001 001
100% 100%
Set Set
001 001
Enter Enter
Set Set 001 001
Enter Enter