Configuring Wccp Multicast; Example Configurations - 3Com SUPERSTACK 3 WEBCACHE 3000 User Manual

322 A G: C
PPENDIX ISCO
Configuring WCCP
Multicast
Example
Configurations
WCCP C
OMMANDS
This rule is applied on a per interface basis and is applied to the interface
connected to the caches. It prevents packets being redirected to the
internet from looping back to the Webcaches.
To enable or disable WCCP multicast on a Cisco router, enter the
following settings in the Cisco Command Line Interface:
1 Enter:
configure terminal
2 Enter the following command:
wccp <service-id> group-address <multicast address>
The multicast must be between 224/8 and address 239.255.255.255.
3 Enter the following command:
wccp <service-id> group-listen
This is for the interface receiving the multicast packets.
Turning on HTTP processing
This will configure the router to capture HTTP traffic on port 80 and
redirect it to the Webcache.
Enter the following commands:
configure terminal
ip wccp <service-id>
interface ethernet0
ip wccp <service-id> redirect out
General
Enter the following commands:
configure terminal
ip wccp <service-id> group-address 224.1.1.100 password 3com
interface ethernet 0
ip wccp <service-id> redirect out
interface ethernet 1
ip wccp <service-id> group-listen