3Com SUPERSTACK 3 WEBCACHE 3000 User Manual page 97

The device mimic is a virtual, interactive representation of the front and
rear panels and the current status of the Webcache. All of the ports on
the Webcache are shown. The device mimic is periodically updated to
reflect changes in the Webcache. You can also perform certain operations
by clicking on parts of the device mimic called "hotspots":
Cache Storage Device Hotspots
I
The cache storage device bays on the front panel mimic for the
Webcache 3000 are "hotspots". Click one of the bays to open a
pop-up menu that contains operations which you can launch for that
cache storage device.
The operations are Add Storage and Remove Storage.
For further information, see
The Cache Storage Device Hotspots are not available on the device mimic
for the Webcache 1000 because cache storage devices cannot be added
or removed.
Console Port Hotspot
I
The Console Port on the rear panel mimic is a "hotspot". Click the
port to open a pop-up menu that contains an operation which you
can launch for the console port.
The only operation available through this hotspot is Setup Console
Port.
WAN/LAN Port Hotspots
I
The WAN and LAN Ports on the rear panel mimic are "hotspots". Click
the WAN or LAN port to open a pop-up menu that contains an
operation which you can launch for that port.
The only operation available through these hotspots is Port Setup.
For further information, see
page 63.
The device mimic also has three Controls, which are buttons that you can
use to control the mimic and its appearance and to provide help
information:
Polling Interval
I
Click this to set the rate at which the device mimic is refreshed. The
default rate is 30 seconds.
Poll Now
I
The Information Area
"Preloading Content"
"Configuring the WAN and LAN
97
on page 193.
Ports"on