Accessing The Webcache Via The Console Line; Accessing The Webcache Via Telnet - 3Com SUPERSTACK 3 WEBCACHE 3000 User Manual

276 C 19: P
HAPTER ROBLEM
Accessing the
Webcache via the
Console Line
Accessing the
Webcache via
Telnet
S
OLVING
The terminal or terminal emulator cannot access the Webcache.
Check that:
Your terminal or terminal emulator is correctly configured to operate
I
as a generic (TTY) terminal, or a VT100 terminal.
You have performed the Command Line Interface wake-up procedure
I
by pressing [Return] a few times.
The settings on your terminal or terminal emulator are correct and
I
match those set for the Webcache console port:
8 data bits
I
no parity
I
1 stop bit
I
9600 baud (default)
I
The Webcache only works with line speeds from 1200 to 19,200
baud. The default line speed of the Webcache is 9600 baud.
If the login sequence still does not display, reset the Webcache. For
further information, see
does not work, initialize the Webcache. For further information, see
"Initializing the Webcache"
You cannot access the Webcache using Telnet.
Check that:
The network cables are secure.
I
The network cable used to access the Webcache is connected to the
I
LAN port.
The Port Activity LED on the Webcache LAN port is Green or Green
I
Flashing.
The duplex settings are as expected by the rest of your network.
I
You can ping the Webcache.
I
The terminal or terminal emulator is set to VT52 or VT100 mode.
I
Press Return a few times to wake up the CLI.
I
The terminal or terminal emulator can no longer access the
Webcache over the network.
"Rebooting the Webcache"
on page 267.
on page 268. If this