Saving A Configuration - 3Com SUPERSTACK 3 WEBCACHE 3000 User Manual

Saving a
Configuration
If you had not previously saved a system configuration file for the older
software version, you would still be able to install a previous software
image, but you would have to re-enter all of the configuration settings.
CAUTION: You cannot restore a system configuration which was created
on a different software version to the version that the Webcache is
currently running.
Example: You save a configuration when the Webcache is running
software version 1.00. You later perform a software upgrade to version
1.01 and attempt to restore the 1.00 system configuration to the
Webcache. The Web interface will not allow you to restore the
configuration.
Therefore you should save a configuration file for each different software
version that you run on the Webcache. If you need to go back to an
earlier software version via a software installation, you can use a
matching configuration file to restore the settings.
To save the current system configuration of the Webcache using the Web
interface:
1 Log in to the Web interface.
2 Click Device on the Toolbar.
3 Select System > Control > Save Configuration in the Navigation Tree. The
Save Configuration screen is displayed.
4 Click Save.
5 Your Web browser prompts you to enter a filename and to choose a
location. When you have entered the required information, click OK. The
save process may take a few seconds to complete.
6 Write down the filename and location of the system configuration file for
future reference. You should repeat this for every configuration that you
save.
7 The Save Configuration screen in the Web interface does not close
automatically when the save process has been completed. Click Cancel to
close the screen when the configuration has been saved.
You can exit the Save Configuration screen without saving a system
configuration file by clicking Cancel instead of Save.

Saving a Configuration

237