Adding A New Cache Storage Device - 3Com SUPERSTACK 3 WEBCACHE 3000 User Manual

316 A F: R
PPENDIX EPLACING AND
Adding a New Cache
Storage Device
I C
NSTALLING ACHE
9 Close the front panel of the Webcache.
10 Return the cache storage device to 3Com.
For further information about returning a failed cache storage device to
3Com, enter the following URL into your Web browser:
http://knowledgebase.3com.com/division/publisher.asp?id=2.0.
77094716.3290900
(correct at time of publication)
You can use a new cache storage device supplied by 3Com to replace the
failed device.
To add a cache storage device to the Webcache 3000:
1 If you have mounted the Webcache in a rack using the supplied
rack-mounting kit, you must slide the Webcache forward by
approximately 1 inch, in order to fully open the front panel.
2 Open the front panel of the Webcache, as shown in
page 315.
3 The new cache storage device is mounted in a tray. Insert the tray into
bay 1 or 2 in the Webcache and push it forwards firmly until it stops.
4 Push in the arms on the front of the tray to click them into place.
5 Close the front panel of the Webcache.
6 Log in to the Web interface.
7 Click Device on the Toolbar.
8 Select System > Storage > Add Disk in the Navigation Tree. The Add
Cache Storage screen is displayed.
You can also open this screen by clicking the cache storage device that
you want to remove on the Device Mimic and selecting Add Storage from
the pop-up menu. For further information, see
page 96.
9 Select the cache storage device that you want to add from the Select the
Cache Storage Device list. Click Add.
10 The Webcache automatically starts preparing the new cache storage
device for use. The Cache Storage Status LED on the front panel changes
to Green Flashing whilst the device is being prepared and then to Green
when it is in use. For further information about LEDs, see
page 61.
S D
TORAGE EVICES
Figure 37 on
"Device Mimic" on
"LEDs" on