Rebooting The Webcache; Setting The Webcache Snmp Community String - 3Com SUPERSTACK 3 WEBCACHE 3000 User Manual

268 C 18: C
HAPTER OMMAND
Rebooting the
Webcache
Setting the Webcache
SNMP Community
String
L I
INE NTERFACE
CAUTION: Use great care when initializing the Webcache. It removes all
configuration information, including password and security information.
The Webcache is rebooted, which takes approximately 60-90 seconds.
While the Webcache is being rebooted, you cannot communicate with it.
You can reboot the Webcache using the
Control menu.
To reboot the Webcache:
1 At the Top-level menu, enter:
system control reboot
The following prompt is displayed:
Are you sure you want to reboot the system (yes,no) [no]:
2 Enter if you wish to proceed, or
yes
What Happens During a Reboot?
Rebooting the Webcache simulates a power-off/on cycle. The Telnet
session to the Webcache will be terminated.
The Webcache takes about approximately 60-90 seconds to reboot.
While the Webcache is being rebooted, you cannot communicate with it.
You can change the Public and Private SNMP community strings for the
Webcache using the
For further information, see
page 212.
3Com recommends that you change the default community strings to
prevent unwanted users from gaining access to the Webcache.
To change the community strings:
1 At the Top-level menu, enter:
system management community
The following prompt is displayed:
Enter new Private (Set/Write) community [private]:
2 Enter the community string for Private (Set/Write) requests to the
Webcache.
reboot
if you want to stop the reboot.
no
command on the Management menu.
community
"Configuring SNMP Community Strings"
command on the
on