Leds Of S5500-28C-Pwr-Si/S5500-52C-Pwr-Si Switch - H3C LS-5500-28C-PWR-SI-OVS Installation Manual

Installation Manual
H3C S5500-SI Complete Series Ethernet Switches
LED
10/100/1000BAS
E-T Ethernet port
status LED
1000Base SFP
port status LED

1.3.2 LEDs of S5500-28C-PWR-SI/S5500-52C-PWR-SI Switch

The S5500-28C-PWR-SI/S5500-52C-PWR-SI Ethernet switch provides LEDs on the
front panel for your convenience to monitor the switch. Table 1-4 describes the
meanings of the LEDs. You can use the Mode button on the panel to switch the display
mode (rate mode, duplex mode, or PoE mode) of LEDs.
Mark Status
Rate
mode
—
Duplex
mode
This LED
is not
influence
—
d by the
mode
button
1-12
Chapter 1 Product Overview
Description
The port works at the rate of
1000 Mbps; the LED blinks
Green
quickly when the port is
sending or receiving data.
The port works at the rate of
10/100 Mbps; the LED blinks
Yellow
quickly when the port is
sending or receiving data.
Yellow,
blinking
POST fails on the port.
(3 Hz)
OFF The port is not connected.
The port works in full duplex
mode; the LED blinks quickly
Green
when the port is sending or
receiving data..
The port works in half duplex
mode; the LED blinks quickly
Yellow
when the port is sending or
receiving data..
Yellow,
blinking POST fails on the port.
(3 Hz)
OFF The port is not connected.
The port works at the rate of
1000 Mbps; the LED blinks
Green
quickly when the port is
sending or receiving data.
Yellow,
blinking POST fails on the port.
(3 Hz)
OFF The port is not connected.