Front Panel Leds Of The S3100-Tp-Si And S3100-Tp-Ei Series - H3C S3100-8TP-SI Installation Manual

Table 1-9 Description of port status LEDs on S3100-T-SI, S3100-C-SI, S3100-TP-PWR-EI, and
S3100-C-EPON-EI series Ethernet switches
Port status
mode LED
The A/L LED
is on
The D/S LED
is on
You can switch the mode of the port status LEDs by pressing the Mode button. After a switch is powered
on, the A/L LED is on initially. If you press the Mode button, the D/S LED will be on. After that, if you
press the Mode button again within 45 seconds, the A/L LED will be on again. Otherwise, the A/L LED
will automatically be on 45 seconds later.
1000 Mbps Uplink Port Status LED
Table 1-10 Description of 1000 Mbps uplink port status LED on S3100-T-SI, S3100-C-SI,
S3100-TP-PWR-EI and S3100-C-EPON-EI series Ethernet switches
LED
1000 Mbps uplink port
link LED
1000 Mbps uplink port
active LED

Front Panel LEDs of the S3100-TP-SI and S3100-TP-EI Series

Power LED
Table 1-11 Description of the power LED on the S3100-TP-SI and S3100-TP-EI series
LED
Power LED
Port status LED
Blinking
Yellow LED
(left)
OFF
ON
Green LED
(right)
OFF
ON
Yellow LED
(left)
OFF
ON
Green LED
(right)
OFF
Mark on the panel
LINK
ACT
Mark on the panel
Power
The port is in the active state and there is traffic
on the port.
The port is in the active state but there is no
traffic on the port.
The port is connected properly.
The port is not connected or is incorrectly
connected.
The port operates in the full duplex mode.
The port operates in the half duplex mode.
The port rate is 100 Mbps.
The port rate is 10 Mbps.
Status
ON The port is connected properly.
The port is not connected or is
OFF
incorrectly connected.
The port is in the active state and
Blinking
there is traffic on the port.
The port is in the active state but
OFF
there is no traffic on the port.
Status
ON The switch is powered on.
OFF The switch is powered off.
1-32
Description
Description
Description