Table of Contents
Advertisement
Installation Manual
H3C S5500-SI Complete Series Ethernet Switches
Figure 4-3 Set the serial port used by the HyperTerminal connection
3)
Click <OK> after selecting a serial port and the system pops up the following
interface. On the interface, set "Bits per second" to 9,600, "Data bits" to 8, "Parity"
to "none", "Stop bits" to 1, and "Flow control" to "none".
Figure 4-4 Set serial port parameters
Chapter 4 Powering on the Switch for the First Time
4-3
Hide quick links:
Advertisement
Table of Contents
