H3C LS-5500-28C-PWR-SI-OVS Installation Manual page 73

Installation Manual
H3C S5500-SI Complete Series Ethernet Switches
Figure 5-5 Page for file sending
Step 9: After the download completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Note:
You do not need to reset the HyperTerminal's baud rate and can skip the last step if you
have chosen 9600 bps. In this case, the system displays the prompt "BootROM is
updating now.....................................done!" instead of the prompt "Your baudrate
should be set to 9600 bps again! Press enter key when ready".
Step 10: Reset HyperTerminal's baud rate to 9600 bps (refer to Step 4 and 5). Then,
press any key as prompted. The system will display the following information to show
the loading process is done.
Bootrom updating.....................................done!
III. Loading host software
Step 1: Select 1 in Boot Menu to load the host software of the switch. The system
displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
To load the host software through XMODEM, select 3.
Chapter 5 Boot ROM and Host Software Loading
5-7