H3C LS-5500-28C-PWR-SI-OVS Installation Manual page 65

Installation Manual
H3C S5500-SI Complete Series Ethernet Switches
than <Ctrl + B> within five seconds, the system begins to automatically start up and the
following information is displayed:
Auto-booting...
Decompress Image..........................................................
..........................................................................
..........................................................................
..........................................................................
..........................................................................
..........................................................................
...OK!
Starting at 0x80100000...
User interface aux0 is available.
Press ENTER to get started.
The appearance of "Press ENTER to get started" indicates that the automatic startup of
the switch is complete.
Press <Enter>. The following prompt is displayed:
<H3C>
You can configure the switch now.
Initialize:
LSP1LTSUA..................................OK!
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Subslot 1 (LSP1XP2P) selftest..............OK!
Subslot 2 (LSP1XP2P) selftest..............OK!
Please check leds....................FINISHED!
4-9
Chapter 4 Powering on the Switch for the First Time