Related Manuals for H3C LSQM1TGS24QSA0
Summary of Contents for H3C LSQM1TGS24QSA0
- Page 1 H3C LSQM1TGS24QSA0 Interface Card User Manual New H3C Technologies Co., Ltd. http://www.h3c.com Document version: 6PW103-20190730...
- Page 2 Ne w H3C Technologies Co., Ltd. Trademarks Except for the t rademarks of New H3C Technologies Co., Ltd., an y trademarks that may be mentioned in this document are the property of their respective owners. Notice The information in this document is subject to change without notice.
-
Page 3: Table Of Contents
Contents Introduction ··············································· 1 Overview ······································································· 1 LEDs ············································································ 2 Installing and removing an interface card ········· 4 Installing an interface card ················································ 4 Removing an interface card ·············································· 6 Installing and removing SFP, SFP+, and QSFP+ transceiver modules and DAC cables ·················································... -
Page 4: Introduction
Introduction Overview LSQM1TGS24QSA0 interface cards are similar in appearance. Each provides 24 SFP+ ports and two QSFP+ ports. Figure 1 LSQM1TGS24QSA0 interface card front panel (1) SFP+ port LED (2) QSFP+ port LED (3) QSFP+ port (4) SFP+ port NOTE: •... -
Page 5: Leds
For more information about H3C QSFP+ transceiver modules, QSFP+ DAC ca bles, QSFP+ optical cables, and QSFP+ to SFP+ cables, see Transceiver Modules User Guide at www.h3c.com. LEDs Table 1 describes SFP+ port LEDs. Table 2 describes QSFP+ por t LEDs. - Page 6 LED status Description The port is sending or receiving data at 40 Flashing green Gbps. A transceiver module is installed in the port. Steady yellow The port is operating at 10 Gbps, and a link is present on the port. The port is sending or receiving data at 10 Flashing yellow Gbps.
-
Page 7: Installing And Removing An Interface Card
The installation and removal procedures ar e the same f LSQM1TGS24QSA0 interface cards. Installing an interface card Before you install an interface card, remove the filler panel (if an y) from the target slot. Keep the re moved filler panel secure for futu re use. - Page 8 Figure 2 LSQM1TGS24QSA0 interface card (1) Ejector lever (2) Latch Press the latch on the interface card to release the ejector lever. As shown by callout 1 in Figure 3, insert the interface card slowly into the slot along the guide rails.
-
Page 9: Removing An Interface Card
Removing an interface card CAUTION: • Before you remove an interface card, remove the cable from it to avoid cable damage. • After removing an interface card, if no new interface card is to be installed, install the filler panel as soon as possible to prevent dust and ensure good ventilation in the device. -
Page 10: Installing And Removing Sfp, Sfp+, And Qsfp+ Transceiver
Installing and removing SFP, SFP+, and QSFP+ transceiver modules and DAC cables For information about installing and removing SFP/SFP+ transceiver modules and SFP+ DAC ca bles, see H3C SFP/SFP+/XFP Transceiver Modules Installation Guide at www.h3c.com. For information about installing and removing QSFP+ transceiver...
Need help?
Do you have a question about the LSQM1TGS24QSA0 and is the answer not in the manual?
Questions and answers