S5130S-28C-Pwr-Hi - H3C S5560S-EI Series Installation Manual

S5130S-28C-PWR-HI

Figure2-31 Front panel
1 2
(1) 10/100/1000BASE-T autosensing Ethernet port
(2) 10/100/1000BASE-T autosensing Ethernet port LED
(3) SFP port
(5) Management Ethernet port
(7) Micro USB console port
(9) Mode LED (MODE)
(11) System status LED (SYS)
(13) Expansion slot LED (SLOT)
(15) Power supply 1 status LED (PWR1)
(17) SFP+ port LED
Figure2-32 Rear panel
1
(1) Grounding screw
(3) Power supply 1 (PWR1)
The S5130S-28C-PWR-HI switch comes with power supply slot 1 empty and power supply slot 2
installed with a filler panel. You can install one or two power supplies for the switch as required. In
this figure, two PSR720-56A AC power supplies are installed in the power supply slots.
The S5130S-28C-PWR-HI switch provides an expansion slot at the rear panel. It comes with this
expansion slot installed with a filler panel. You can install one expansion module as needed. In this
figure, an LSWM2SP2PB interface module is installed.
3 4
17
2
2-29
5 6 7 8 10
9
13
16 15 14 12 11
(4) SFP port LED
(6) Console port (CONSOLE)
(8) Port LED mode switching button
(10) USB port
(12) SFP+ port
(14) Power supply 2 status LED (PWR2)
(16) Management Ethernet port LED (ACT/LINK)
3
(2) Expansion module
(4) Power supply 2 (PWR2)
4