H3C LS-5500-28C-PWR-SI-OVS Installation Manual page 47

Installation Manual
H3C S5500-SI Complete Series Ethernet Switches
＋ － NULL ＋ － NULL
+: working ground
Figure 3-19 Appearance of the RPS DC power socket of the switch
1) Connect one end of the grounding wire (delivered with the switch) to the grounding
screw and the other end to the ground nearby.
2) Insert the connector into the DC socket directly. Use the flat-blade screwdriver to
fix the connector with screw 1 and screw 2 (delivered with the switch), as shown in
Figure 3-20.
Note:
The position of the power socket on a device varies with devices. Refer to the real
device for the power socket position.
Figure 3-20 Fix the RPS DC power connector to the chassis
3) Check whether the PWR LED on the front panel of the switch is ON. If the LED is
ON, it shows the power cord is properly connected.
-: -52 VDC to -55 VDC
3-14
Chapter 3 Installing the Switch
NULL: Reserved