1Gef/2Gef Module; Introduction; Appearance; Figure 8-17 1Gef Module - H3C SECPATH F1000-S,SECPATH F1000-S HOST Installation Manual

Installation Manual
H3C SecPath F1000-S Firewall
Step 2: Power up the firewall and check the state of the LED for the module on the front
panel of the firewall. ON means the module has passed the POST and can operate
normally; OFF means the POST fails. In the latter case, contact your agent for help.
Step 3: Check the state of the LINK LED on the 1GBE/2GBE module panel. ON means
a link is present. OFF means no link is present; check the line for the cause.

8.6 1GEF/2GEF Module

8.6.1 Introduction

1-/2-port 1000Base-LX/1000Base-SX Ethernet optical interface module (1GEF/2GEF)
can provide the communications between the firewall and a LAN.
The 1GEF/2GEF module can be multimode short-haul (850 nm), single mode
medium-haul (1310 nm), single mode long-haul (1310 nm), single mode long-haul
(1550 nm), and single mode ultra-long haul (1550 nm). You can purchase them as
needed.
The 1GEF/2GEF module supports:
The operating rate of 1000 Mbps
Full duplex mode

8.6.2 Appearance

Figure 8-17 and Figure 8-18 show respectively the 1GEF and 2GEF modules.

Figure 8-17 1GEF module

Figure 8-18 2GEF module

Chapter 8 Multifunctional Interface Modules
8-12