H3C SECPATH F1000-S,SECPATH F1000-S HOST Installation Manual page 45

Installation Manual
H3C SecPath F1000-S Firewall
Net Port Download Menu:
1:
2:
3:
Enter your choice(1-3): 1
Step 2: Select 1 to configure the network interface parameters (including the interface
in use and the IP address and subnet mask of the interface) and the TFTP server
parameters (including the IP address of the Ethernet interface on the PC and the file
name of the application program).
Change Download parameter
Download device
Download file(Max 60 char)
IP address of ETH0/1
Subnet mask for ETH0/1
IP address of the server
IP address of the gateway
Caution:
The upgrade should be performed through interface ETH0/1 on the firewall.
The item "IP address of the server: [192.168.1.10]" must be set to the IP address of
the TFTP server connected to the Ethernet interface on the firewall.
You are recommended to configure the IP address of the Ethernet interface on the
TFTP server and that of the ETH0/1 on the firewall into the same network segment.
Step 3: After you input the last parameter value, the system displays the following
message and then returns to the Net Port download menu:
Saving config, please wait...OK!
Net Port Download Menu:
1:
2:
3:
Enter your choice(1-3): 2
3) Select 2 to download the application program using TFTP. The system displays
the following message:
Starting the TFTP download...
..........................................................................
.......................
TFTP download completed, Packet length 8790321 bytes.
Change Net Parameter
Download From Net
Exit to Main Menu
Change Net Parameter
Download From Net
Exit to Main Menu
Chapter 5 Software Maintenance
: ETH0/1
: system
:192.168.1.15
:255.255.255.0
:192.168.1.10
:10.110.95.117
5-7