Verifying Installation - H3C SECPATH F1000-S,SECPATH F1000-S HOST Installation Manual

Installation Manual
H3C SecPath F1000-S Firewall
II. Recommended power socket
You are recommended to use a single-phase three-terminal socket with a ground
contact, which must be properly grounded. The building ground system is often buried
during the wiring engineering. Make sure that the building ground system is normal
before connecting the AC power cord.
III. Connecting an AC-input PSU
Take the H3C SecPath F1000-S firewall for example.
Step 1: Make sure that the grounding screw on the chassis is securely connected to the
earth ground.
Step 2: Make sure that the power switches are placed in the OFF position. Connect one
end of an AC power cord provided with the device to the socket of AC-input PWR0 on
the left-rear of the chassis and the other end to the AC site power.
Step 3: Repeat Step 2 to connect the PWR1. (Skip this step if you use only one PSU.)
Step 4: Place the PWR0 switch to the ON position.
Step 5: Place the PWR1 switch to the ON position. (Skip this step if you use only one
power switch.)
Step 6: Check that the PWR0 and PWR1 LEDs on the front panel light. ON means the
power connections are correct.
Step 7: Check that the SYS LED on the front panel is ON. ON means the hardware
system is working well.

3.8 Verifying Installation

Each time you power up the device during the installation, verify that
The device has adequate clearance around it for heat dissipation and the
workbench/table/rack is stable enough.
The proper power supply is used.
The grounding wire is correctly connected.
The device is correctly connected to other devices, such as a console terminal.
Note:
Installation verification is extremely important, because the operations of the firewall
depend on its stability, grounding, and power supply.
3-9
Chapter 3 Hardware Installation