Module Attributes; Panel And Module Leds; Figure 8-21 Ssl Module; Figure 8-22 Ssl Module Panel - H3C SECPATH F1000-S,SECPATH F1000-S HOST Installation Manual

Installation Manual
H3C SecPath F1000-S Firewall

Figure 8-21 SSL module

8.7.3 Module Attributes

Table 8-9 shows the attributes of the SSL module.

Table 8-9 SSL module attributes

Attribute
Supported protocol
Hardware algorithm

8.7.4 Panel and Module LEDs

Figure 8-22 shows the panel of the SSL module.

Figure 8-22 SSL module panel

Table 8-10 LEDs on the SSL module

LED
STATUS
ACTIVE
SSL
Key algorithm (DES, 3DES, AES and RC4)
Authentication algorithm (HMAC-MD 5and HMAC-SHA-1)
ON means module is not powered normally;
OFF means the module is not powered, or the power supply is
OFF or in fault.
Blinking for two seconds and then OFF means the module
initialization is completed; blinking continuously means the
module is normal and packets are being transmitted/received on
the interface; OFF means the module is normal but no packets are
being transmitted/received on the interface; .
8-16
Chapter 8 Multifunctional Interface Modules
Description
Description