Powering Up The Firewall; Figure 4-5 Select Emulation Type - H3C SECPATH F1000-S,SECPATH F1000-S HOST Installation Manual

Installation Manual
H3C SecPath F1000-S Firewall

Figure 4-5 Select emulation type

4.1.2 Powering up the Firewall

I. Checking before power-up
Before powering up the firewall, check that
Both the power cord and the grounding wire are correctly connected.
Proper power supply is used.
The console cable is correctly connected.
The console terminal (or PC) has been started and the related parameters have
been set on it.
Caution:
Locate the emergency power-off switch in the room before powering up the firewall.
Then, if an accident occurs, you can quickly shut off the power.
Chapter 4 Booting and Configuration
4-4