Figure 5-1 Send File Dialog Box - H3C SECPATH F1000-S,SECPATH F1000-S HOST Installation Manual

Table of Contents

Installation Manual

H3C SecPath F1000-S Firewall

I. Upgrading the application program

Step 1: Enter the Boot menu and enter 1 to download an application program using

XModem. The firewall supports the following download speeds:

Downloading application program from serial ...

Please choose your download speed:

1: 9600 bps

2: 19200 bps

3: 38400 bps

4: 57600 bps

5: 115200 bps

6: Exit to Main Menu

Enter your choice(1-6):

Step 2: Choose an appropriate download speed (for example, 115200 bps by entering

5). The following message appears:

Download speed is 115200 bps. Change the terminal's speed to 115200 bps, and

select XModem protocol. Press ENTER key when ready.

Step 3: Change your terminal's baud rate (see Figure 4-4) to the same baud rate for

software downloading (115200 bps in this example). After that, disconnect the terminal

([Dial-in/Disconnect]), reconnect it ([Dial-in/Dialing]), and press <Enter> to start

downloading. The system displays this message:

Downloading ... CCCCC

Note:

The new baud rate takes effect only after you reconnect the terminal emulation

program.

Step 4: Select [Transmit/Send File] in the terminal window. The following dialog box

pops up:

Figure 5-1 Send File dialog box

Chapter 5 Software Maintenance

5-3

Table of Contents

Do you have a question about the H3C SECPATH F1000-S,SECPATH F1000-S HOST and is the answer not in the manual?