Table of Contents
Advertisement
Installation Manual
H3C SecPath F1000-S Firewall
Chapter 5 Software Maintenance
5.1 Introduction
The firewall maintains three types of files:
Boot ROM program files
Application program files
Configuration files
The
software
ROM/application program files and uploading/downloading configuration files.
5.1.1 Boot Menu
This section introduces the Boot menu that you use in maintaining the software of the
firewall.
Set up a configuration environment as shown in Figure 4-1 and then boot the firewall.
Press <Ctrl+B> when the system prompts "Press Ctrl-B to enter Boot Menu...". The
system displays this message:
Please
Caution:
Press <Ctrl+B> within three seconds after the prompt "Press Ctrl-B to Enter Boot
Menu..." appears to access the Boot menu. Otherwise, the system starts
decompressing the program.
If you want to access the Boot menu after the system starts decompressing the
program, you need to reboot the firewall.
Type the correct password and press <Enter> (if no Boot ROM password is configured,
just press <Enter>). The system accesses the Boot menu.
I. Boot menu of the H3C SecPath F1000-S firewall
Boot Menu:
1:
2:
3:
4:
maintenance
input Boot ROM password :
Download application program with XMODEM
Download application program with NET
Display file in flash
Delete file from flash
mainly
involves
upgrading/downloading
5-1
Chapter 5 Software Maintenance
Boot
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the H3C SECPATH F1000-S,SECPATH F1000-S HOST and is the answer not in the manual?