1Gef/2Gef Module; Introduction; Appearance; Figure 8-17 1Gef Module - H3C SECPATH F1000-A,SECPATH F1000-A HOST Installation Manual

Installation Manual
H3C SecPath F1000-A Firewall
operate normally; OFF means the POST fails. In the latter case, contact your agent for
help.
Step 3: Check the status of the LINK LED on the 1GBE/2GBE module panel. ON
means a link is present. OFF means no link is present; check the line for the cause.

8.6 1GEF/2GEF Module

8.6.1 Introduction

1-/2-port 1000Base-LX/1000Base-SX Ethernet optical interface module (1GEF/2GEF)
can provide the communications between the firewall and a LAN.
The 1GEF/2GEF module can be multi-mode short-haul (850 nm), single mode
medium-haul (1310 nm), single mode long-haul (1310 nm), single mode long-haul
(1550 nm), and single mode ultra-long haul (1550 nm). You can purchase them as
needed.
The 1GEF/2GEF module supports:
The operating rate of 1000 Mbps
Full-duplex mode

8.6.2 Appearance

Figure 8-17 and Figure 8-18 show respectively the panel of the 1GEF and 2GEF
modules.

Figure 8-17 1GEF module

Figure 8-18 2GEF module

Chapter 8 Multifunctional Interface Modules
8-12