Startup Process - H3C MSR 30-20 ROUTER Installation Manual

1) The LEDs on the front panel show that the router is operating normally.
2) The console terminal displays normally.
For local configuration, after you power on the router, you can see the startup banner. See section

257260720 "Startup Process".

3) After completing the power-on self-test (POST), the system asks you to press <Enter>. When the
prompt appears, you may proceed to configure the router.

Startup Process

During the power-on or reboot process, the router first initializes its memory:
InitDDR
Then the router runs BootROM, and the console terminal displays the following information:
system start booting......Version
Press CTRL+D to stop auto-boot
Press <Ctrl+D> and the system will enter the basic BootROM segment menu; otherwise, the system will
enter the decompression process of the extended BootROM segment.
Enter <Ctrl+D> within 3 seconds after the "Press CTRL+D to stop auto-boot" appears, the system can
enter basic BootROM segment menu; otherwise, the system will enter the decompression process of
the extended BootROM segment.
Booting Normal Extended BootRom
Decompressing...done!
Ensure the baudrate is set to 9600bps!Starting at 0xa00000...
*******************************************************
*
*
*
*******************************************************
Copyright(c) 2004-2007
Compiled date: Apr 09 2007, 08:52:28
CPU type
CPU L1 Cache
CPU Clock Speed : 533MHz
Memory Type
Memory Size
Memory Speed
BootRom Size
CPLD
MSR30-20 BOOTROM, Version 2.11
: MPC8349E
: 32KB
: DDR SDRAM
: 256MB
: 266MHz
: 4096KB
Version is 1.00
2.11
4-4
*
*
*