Start Delay ( Glid 1A+1F Only); Camber Mix - FUTABA 10CAP Instruction Manual

START DELAY ( GLID 1A+1F only):

Adjustability:
• Delay time ( -dly- ) range of 0 to 100%. The delay time is 10 second at 100%.
GOAL of EXAMPLE:
Ex: delay time=5 second.
Camber Mixing ( CAMBER MIX )( GLID ):
Adjustability:
• Rate: -100% to +100%, with a default of +30%
• Reference point ( PRE ): The operation reference point of camber control can be offset. -100% to +100%, with a default of 0%.
GOAL of EXAMPLE:
Ex: Set the mixing amount for aileron
to 40 %, camber control to VR(E),
reference point to desired point.
START DELAY automatically switch the offset trims ( OFFSET ) from the START
condition's trims to the normal cndition's trims after proceeding the delay time
(max.10sec.) which is set by the -dly- item when activating the START condition.
(It is convenient for hand launch glider.)
NOTE: The same delay amount for elevator and rudder is recommended when
using V-tail function.
STEPS:
Open ADVANCE menu, then open START
DELAY function.
Activate the function.
Set the delay time.
(Ex: 50% each surface)
Close.
This function adjusts the mixing rate of camber operation which operates the
changes caused by camber operation can be corrected.
Also the operation reference point of camber control can be offset. ( PRE )
NOTE: Camber control is not assigned at initial.
STEPS:
Open the CAMBER MIX function.
Choose desired slider.
Adjust the mixing amount for AILE .
(Ex: adjust to 40% .)
Set the reference point.
Close menu.
85
INPUTS:
for 1 second.
(If ADVANCE ,
C to START DELAY .
C to MIX . to OFF or ON .
C to ELEV . to 5O% .
C to RUDD . to 5O% .
Repeat as needed.
INPUTS:
for 1 second.
(If BASIC ,
C to CAMBER MIX .
C to VR . to VR(E).
to AILE .
C VR(E).
to 40% .
VR(E).
C to PRE . or
desired point. for one second.
again.)
again.)
to 40% .
VR(E) to