FUTABA 10CAP Instruction Manual page 70

GOAL of EXAMPLE:
Set up a FLAP-ELEV mix:
ON when SWITCH C is in the down
position.
up (spoilers),
5% elevator movement when flaps
move down,
LINK should be ON if model has twin
e l e v a t o r s e r v o s . O t h e r w i s e , LINK
remains OFF .
(Flap has no trim lever, so TRIM is not
an option.)
Where next?
Other Examples:
• RUD-ELEV ( ACRO GLID ) mix: Compensate for pitching up or down when rudder is applied.
• AIL-RUD mix ( ACRO ): Coordinate turns by applying rudder automatically with aileron input. All model types.
• ELEV-PIT ( HELI ) mix: compensate for the loss of lift of tilting the model.
STEPS:
Open an unused programmable mix.
(Ex: use PROG.MIX3 since it is already
set-up for FLAP-ELEVATOR .)
Activate the function.
Choose master and slave channels.
(Ex: no need to change MASTER/SLAVE .)
Optional: set Master as OFST or VR(A-E) .
See above for details.
Set LINK and TRIM as needed.
(Ex: leave LINK OFF , TRIM not available.)
Assign SWITCH and position.
(Ex: change from E to C , DOWN .)
Optional: set switch to STk-THR to
activate mix with THROTTLE STICK.
(See above for details.)
Optional: set switch position to NULL .
Makes mix active at all times. Not
compatible with STk-THR .
Set rates. (Ex: Lo= 0% , Hi= 5% .)
Set OFFSET , if needed. (Ex: 0 .)
Close menu.
Adjust servo END POINTs : see p. 39.
Set up additional programmable mixes, ex: RUDDER - AILERON : see p. 68.
View numerous additional mix setups: www.futaba-rc.com\faq\
70
INPUTS:
for 1 second.
(If BASIC ,
C to PROG.MIX- .
C to 3 > .
C to MIX . to ON .
already CH6
already CH2
C to MASTER . to desired choice.
C to SW . to C .
C to POSI . to DOWN .
C to SW . to STk-THR .
to POSI .
C
THROTTLE STICK to desired
point.
for 1 second to set.
to POSI . to NULL .
C
C to RATE .
VR(A) past center. Leave at 0% .
VR(A) past center.
to OFFSET . Leave at 0% .
C
D/R , EXP ): see p. 42.
again.)
to 5% .