FUTABA 10CAP Instruction Manual page 117

PITCH CURVE : ( HELI
STICK
Adjusted to provide ideal blade response for various types of maneuvers being performed. For simplicity, the normal
condition's curve may be set in the BASIC menu. All 5 curves are also adjustable in the ADVANCE menu. ......................... 99
PPM: Pulse Position Modulation. Also known as FM. Type of signal transmission. See Modulation.
Programmable mix: used to cause specific servo responses to specific inputs separate from the basic control setups.
........................................................................................................ 68
............................................................................................................................................ 18
Rate: amount of control given. Ex: see Programmable mix.
RESET : to delete all data in the existing model only. User CANNOT erase all data in the radio. Only service center can do
so. Part of PARAMETER submenu. ......................................................................................................................................... 33
..................................................... 74
REVERSE : servo reversing. Used to reverse the direction of a servo to ease installation and set up. .................................... 38
Rudder-to-aileron mix: ( ACRO GLID ) used to counteract undesirable roll (roll coupling) that happens with rudder
input, especially in knife-edge. Gives proper aileron input to counteract roll coupling when rudder is applied. Not a
preprogrammed mix. See Programmable mix. This is the default programming for one linear and one curve mix in ACRO
and GLID .
Rudder-to-elevator mix: used to counteract undesirable pitch (pitch coupling) with rudder input, especially in knife edge
Programmable mix. This is the default programming for one curve mix in ACRO .
Rudder-to-throttle mix: ( HELI ) adds throttle to counter the added load from increasing pitch of the tail blades, maintaining a
constant head-speed with rudder. (This is a minor effect and is not critical in most helicopters.) Not a preprogrammed mix.
See Programmable mix.
Rx: receiver.
SAFE MODE : feature in snap roll programming that does not allow a snap roll if landing gear is lowered. See Snap roll.
Sailplane: glider, non-powered model aircraft type. See GLID MODEL TYPE .
Select a model: see MODEL SELECT .
Service Center. ....................................................................................................................................................................... 3
SERVO
user movements. Also includes a servo test feature. ............................................................................................................ 49
Servo reversing: see REVERSE .
Servo Slow: see Channel delay.
Servo testing, servo display: See SERVO .
SET : to accept. Usually done by pressing and holding the dial when instructed.
Slave: channel that moves in response to the command of the master. See Programmable mix.
Slaving servos: see programmable mix. ............................................................................................................................. 68
Slider assignability: sliders on side of radio, known as VR(D) and VR(E) in programming, may be assigned to control
channels 5-8 in AUX-CH , used as the primary control of a mix in programmable mixes, etc.
Slow: see Channel delay.
Smoke system: injects a specialized smoke oil into the hot exhaust to create air-show like smoke trails. ......................... 74
SNAP ROLL : ( ACRO
117