Changing Mode; Power Down Mode (Tm10 Module); Campac - FUTABA 10CAP Instruction Manual

Changing Modes ( TX SETTING ):
Throttle Reverse: THR-REV is a special function that reverses the entire throttle control, including moving the trim
functionality to the Stick's upper half. To use THR-REV , CURSOR DOWN to THR-REV and turn the DIAL to REV . Turn the
transmitter off and back on. This change affects all models in the radio.
Display language: can be selected the display language of the function name, etc. in each function menu. The screen reads
" LANGUAGE ". Change this to the desired language.
TM-10 Area Selection (Frequency Range) (TM-10 module only):
The TM-10 transmitter module has been designed to function in many countries. If you will be utilizing this module in a
country other than France, please make sure that TM10-MODE is set to " GENERAL ". If, however, this module will be utilized
in France, it must be set to " FRANCE ".
[Note] While changing the above modes, the transmitter transmits in PPM mode even if the set-up mode is PCM mode and
the RF power is turned off when using a TM-10 module.
Power Down mode ( TM10 POWER MODE ) (TM-10 module only):
Power Down Mode: To activate the "Power Down Mode" press DIAL and the home screen will appear. During this mode,
the RF power is reduced so the range test can be performed. In addition, when this mode is activated the blue LED on the
front of the transmitter starts blinking and the transmitter gives users a warning with a beep sound every 3 seconds.
The "Power Down Mode" continues for 90 seconds and after that the power will go back to the normal level. To exit the
"Power Down Mode" before the 90 seconds, press DIAL again. This mode is available 1 time only so if you need to re-use
this function the transmitter power must be cycled. NEVER
Power Off Mode: To use the RF power off mode, CURSOR DOWN to OFF and press DIAL. During this mode, the RF
power is turned off. The blue LED on the front of the transmitter is turn off.
CAMPac Initializing Method and Data Conversion (T9C/T9CS to T10C):
To initialize the CAMPac, CURSOR DOWN to "Yes" and press DIAL and the check display of "OK?" will appear. Press
DIAL again, the initializing of the CAMPac will start.
home screen will appear. See p.30 for the conversion method.
Hold down MODE and END keys while turning on the transmitter to call TX SETTING menu.
Stick Mode: The screen reads " STK-MODE ". Change this to the correct mode. Note that this will
NOT change the throttle and elevator rachets, etc. Those are mechanical changes that must be
done by a service center.
We have installed a special "Power Down Mode" for doing a ground range check. Hold down
DIAL while turning on the transmitter to call TM10 POWER MODE menu.
Insertion of a new CAMPac or a CAMPac containing data of a different transmitter type will
open EXT-MEMORY menu after turning the transmitter on.
CURSOR lever and then press DIAL and the
17