Motor Cut - FUTABA 10CAP Instruction Manual

Motor cut function ( MOTOR CUT ) ( GLID
AIRBRAKE STICK position. The servo movement is largest at -30%.
Adjustability:
• RATE range of -30 to +30. The servo movement at 0% is maximum slow position of AIRBRAKE STICK. The servo
movement is largest at -30%.
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned.
• POSITION fully assignable, including NULL (mix always off) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
positions of the same SWITCH.
GOAL of EXAMPLE:
Decrease the rate to stop the motor
MUST assign a switch. The default is
NULL .)
Where next?
*Also LOGIC SW(Lsw1 to 3) may be assigned. Set up LOGIC SW : See p. 38.
The switch's location and direction must be chosen. It defaults to NULL to avoid
accidentally assigning it to a switch, which might result in an unintentional dead
STEPS:
Open BASIC menu, then open THR-CUT
function.
Activate the function. Choose desired
switch, and the position which activates
the function.
Close.
Set up TRAINER functions: see p. 47.
Set up twin aileron servos: see p. 51.
Set up twin elevator servos: see p. 57.
79
INPUTS:
for 1 second.
(If ADVANCE ,
to THR-CUT .
C
C to MIX . to OFF or ON .
C to SW . to desired switch.
C to POSI . to desired position.
C to RATE . until turns off.
D/R , EXP ): see p. 42.
again.)