FUTABA 10CAP Instruction Manual page 64

• Twin elevator servos:
• If AILEVATOR is active, the AIL1 and AIL2 settings still only affect FLAPERON or AIL-DIFF servos, NOT the elevator servos.
(they would have the AIL3 and AIL4 settings.)
GOAL of EXAMPLE:
Activate AIRBRAKE on a FLAPERON .
model. Adjust the flaperon travel to
75% ,with negative elevator (push) of
25% .
Where next?
STEPS:
FLAPERON is active.
Open the AIRBRAKE function.
Activate the function.
Adjust the travels as needed.
(Ex:Ailerons each 75% , Elevator -25% .)
O p t i o n a l : d e l a y h o w q u i c k l y t h e
elevator servo responds.
Optional: change the mixing from full
amount upon switch to proportional to
the THROTTLE STICK's proximity to
idle.
Close menu.
Set up ELEV-FLAP mixing: see p. 62.
Set up programmable mixes, for example, FLAP-ELEVATOR : see p. 67.
View additional model setups on the internet: www.futaba-rc.com\faq\.
64
INPUTS:
see FLAPERON instructions.
for 1 second.
(If BASIC ,
C to AIRBRAKE .
Switch C in up position.
to MIX . to OFF .
C
C to AIL1 . to 75% .
C to ELEV . to -25% .
C to AIL2 . to 75% .
C to delay- ELEV . to 25% .
C to MODE . to Linear ( 0% ).
THROTTLE STICK to desired 0
point.
for 1 sec, until beeps
(display changes if new setting is different from prior
setting).
FLAPERON ): see p. 52.
again.)