FUTABA 10CAP Instruction Manual page 60

GOAL of EXAMPLE:
A c t i v a t e S N A P - R O L L . A d j u s t
elevatortravel to 55% , rudder travel to
120%
SAFE-MOD so snaps can not be performed
when gear is down.
snap to 105% .
(Note: using negative percents can
change any of the 4 snap directions. For
example, change snap 1 to "down" by
changing the elevator percent to -100% .)
Where next?
STEPS:
Open the SNAP-ROLL function.
Activate the function.
Adjust the travels as needed. (Ex:
elevator to 55% , rudder to 120% .)
Optional: Activate SAFE-MOD . [Ex: ON
when SWITCH E (10CA) or G (10CH)
is down, meaning snap function is
deactivated when that switch is in the
down position.]
Optional: Assign switches to up/down
and left/right. (Ex: Change to the left/
down snap and adjust rudder to 105% .)
Close menu.
Set up programmable mixes: see p. 61.
View additional setups on the internet:www.futaba-rc.com\faq\.
60
INPUTS:
for 1 second.
(If BASIC ,
C to SNAP-ROLL .
C to MIX . to OFF or ON .
C to ELEV . to 55% .
C to RUDD . to 120% .
E or G up. to SAFE-MODE
C
to ON .
snap switch.
Notice MIX reading is still OFF .
E or G down.
Notice MIX reading changes to ON .
C to SW1 . to A.
C to SW2 . to B.
A down B down.
Repeat steps above to set percentages.
again.)